Best answer
Add the pearlsCut around 24 inches of wire and starting from 2 inches, wrap the wire around the leather roughly three to four times. Make sure the wire is nice and tight, and the loops are close to each other as possible. Make a leather bracelet Next, feed through one of the pearls and bring it down to the wrap you just made.
People also ask
What do you need to make a fake pearl necklace?
The materials you need include a quarter-inch ribbon, sixteen 8mm faux pearls (you could also use these real pearls ), 0.5mm Stretch Magic jewelry cord, an embroidery needle, and a pair of scissors. Start by cutting approximately 18-20 inches of the ribbon, then tie a couple of knots about 6 inches away from one of the ends.
How do you attach pearls to a bracelet?
To begin, hook the pearls onto the wire with knots on both ends about two inches away from the end. From there, add a single pearl every 5 inches and finish on the other end with another pair of pearls. Loosely tie the ends together to secure the bracelet when you wear it.
How many pearls do I need to make a necklace?
All you鈥檒l need 鈥?sixteen pearl beads (with 2mm holes) and approximately two and a half yards of 1.5mm thick leather cord. To begin, hook the pearls onto the wire with knots on both ends about two inches away from the end.
How do you make a necklace out of leather cords?
To start, cut a piece of leather cord that fits tightly around your neck. Next, cut the cord into two equal halves, then use a tapestry needle to make a small hole on the end of one the cords. Thread a four-inch piece of 24-gauge gold wire into the hole you poked, create a wrapped loop, then trim the excess wire.
Leave a Reply