how to make leather and pearl jewelry

People also ask


  • What do you need to make a fake pearl necklace?

  • The materials you need include a quarter-inch ribbon, sixteen 8mm faux pearls (you could also use these real pearls ), 0.5mm Stretch Magic jewelry cord, an embroidery needle, and a pair of scissors. Start by cutting approximately 18-20 inches of the ribbon, then tie a couple of knots about 6 inches away from one of the ends.

  • How do you attach pearls to a bracelet?

  • To begin, hook the pearls onto the wire with knots on both ends about two inches away from the end. From there, add a single pearl every 5 inches and finish on the other end with another pair of pearls. Loosely tie the ends together to secure the bracelet when you wear it.

  • How many pearls do I need to make a necklace?

  • All you鈥檒l need 鈥?sixteen pearl beads (with 2mm holes) and approximately two and a half yards of 1.5mm thick leather cord. To begin, hook the pearls onto the wire with knots on both ends about two inches away from the end.

  • How do you make a necklace out of leather cords?

  • To start, cut a piece of leather cord that fits tightly around your neck. Next, cut the cord into two equal halves, then use a tapestry needle to make a small hole on the end of one the cords. Thread a four-inch piece of 24-gauge gold wire into the hole you poked, create a wrapped loop, then trim the excess wire.

    Be the first to comment

    Leave a Reply

    Your email address will not be published.


    *